How do I clean a dirty bong?
Introduction
Cleaning your bong is the most important part of maintaining your piece. If you don't clean it regularly, it will get dirty and stink up the room. In this guide I'll show you how to properly clean every component of your bong so that it's ready for a fresh smoke session!
Cleaning your bong is much more than just a basic scrub job.
When you're cleaning your bong, it's important to remember that not all of the gunk can be removed with just soap and water. You'll have to get a bit more creative if you want to ensure your bong is clean as can be!
To start, fill up your sink or tub with hot water and place all of your pieces into it. Then add some rubbing alcohol--the higher the proof number (that is, 70% versus 40%), the better--and let them soak for at least 30 minutes to an hour. Afterward, remove them from their bath and wipe down each piece individually with paper towels until no residue remains on its surface; this will take some elbow grease but don't worry about damaging anything; any scratches should buff out over time anyway! Be sure not leave any water behind when rinsing out residual alcohol with fresh tap water before smoking again because this could lead bacteria growth inside which may cause moldy smells when smoking next time around."
The first step is to remove all of the water from the bong.
The first step is to remove all of the water from the bong. This is easily done by placing your thumb over the downstem and using your other hand to pull it out. If you're using an ash catcher or ice catcher, just unscrew it from the main chamber and set it aside so that you can wash those parts separately later on. Next, check for any other accessories that may be attached to your bong (like slides) and remove them as well.
Soak your brush in rubbing alcohol, then scrub down all of the parts of your bong.
Soak your brush in rubbing alcohol and scrub down all of the parts of your bong.
Be sure to rinse out any residual alcohol with water before smoking again!
Be sure to rinse out any residual alcohol with water before smoking again.
Remember to rinse out any residual alcohol with water before smoking again. The alcohol will get you high, but it also has some other uses that are more important to keep in mind:
Alcohol is a disinfectant, so it can be used to clean your bong if you want to get rid of germs or bacteria. This will help keep your bong clean and healthy!
Alcohol is also a solvent, which means that it dissolves other substances (like dirt). This makes it effective at removing dirt from your dirty bong too!
And finally--because of its ability to dissolve things--alcohol can be used as an antiseptic or solvent when cleaning out dirty bongs.
You can clean a dirty bong by soaking it in rubbing alcohol and giving it a good scrubbing
If you're looking for a quick and easy way to clean your dirty bong, there are two options: soaking it in rubbing alcohol and scrubbing it with a brush.
Soak the bong in rubbing alcohol for at least 15 minutes. The longer you leave it in there, the better! This will help loosen up any residue on the inside of your piece.
Scrub all of the parts of your piece with a small brush (like an artist's paintbrush). Make sure that all parts get scrubbed well so that no leftover debris remains after rinsing off all traces of rubbing alcohol later on.
Conclusion
Cleaning your bong is much more than just a basic scrub job. The first step is to remove all of the water from the bong, which will allow you to get rid of any residue left behind by dirty water. Soak your brush in rubbing alcohol, then scrub down all of the parts of your bong before rinsing out any residual alcohol with water again (and smoking some good herb).
Comments
Post a Comment